Service Manual

ip pim bsr-border
Define the border of PIM domain by filtering inbound and outbound PIM-BSR messages per interface.
Syntax
ip pim bsr-border
To return to the default value, use the no ip pim bsr-border command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is applied to the subsequent PIM-BSR. Existing BSR advertisements are cleaned up by time-out. To
clean the candidate RP advertisements, use the clear ip pim rp-mapping command.
ip pim bsr-candidate
To join the Bootstrap election process, configure the PIM router.
Syntax
ip pim bsr-candidate interface [hash-mask-length] [priority]
To return to the default value, use the no ip pim bsr-candidate command.
Parameters
interface Enter the following keywords and slot/port or number information:
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
hash-mask-length (OPTIONAL) Enter the hash mask length. The range is from zero (0) to 32. The default is
30.
priority (OPTIONAL) Enter the priority used in Bootstrap election process. The range is from
zero (0) to 255. The default is zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
944 PIM-Sparse Mode (PIM-SM)