Service Manual

ip pim query-interval
Change the frequency of PIM Router-Query messages.
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The range is
from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ip pim register-filter
To prevent a PIM source DR from sending register packets to an RP for the specified multicast source and group, use this feature.
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list command.
Parameters
access-list Enter the name of an extended access list. Maximum 16 characters.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The access name is an extended IP access list that denies PIM register packets to RP at the source DR based on
the multicast and group addresses. Do not enter this command before creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
Syntax
ip pim rp-address address {group-address group-address mask} override
PIM-Sparse Mode (PIM-SM) 947