Service Manual

Command Modes CONFIGURATION
Command History
Version Description
9.11.0.0 Introduced the acl-name keyword.
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ip pim sparse-mode
Enable PIM sparse mode and IGMP on the interface.
Syntax
ip pim sparse-mode
To disable PIM sparse mode and IGMP, use the no ip pim sparse-mode command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The interface must be enabled (the no shutdown command) and not have the switchport command
configured. Multicast must also be enabled globally (using the ip multicast-lag-hashing command). PIM
is supported on the port-channel interface.
ip pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources, or for a specific set of (S,G) pairs an access list defines.
Syntax
ip pim sparse-mode sg-expiry-timer seconds [access-list name]
To disable configured timers and return to default mode, use the no ip pim sparse-mode sg-expiry-
timer command.
Parameters
seconds Enter the number of seconds the S, G entries are retained. The range is from 211 to
86400.
access-list name (OPTIONAL) Enter the name of a previously configured Extended ACL to enable the
expiry time to specified S,G entries.
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
PIM-Sparse Mode (PIM-SM) 949