Service Manual

Example (#2)
Dell#show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about PIM neighbors that PIM-SM
snooping discovered on a specified VLAN. The valid VLAN IDs range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip pim snooping neighbor commands shown in the following example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-SM-enabled neighbor was
discovered.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time until the
neighbor is removed from the multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [tei 4/8 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [te 4/8 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [te 4/8 ] 00:00:51/00:01:24 v2 0
PIM-Sparse Mode (PIM-SM) 955