Service Manual

Parameters
interface Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a Port Channel interface, enter the keywords port-channel then a number.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
hash-mask-length (OPTIONAL) Enter the hash mask length for RP selection. The range is from 0 to 128.
The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election process. The range is from 0
to 255. The default is 0.
Defaults Refer to Parameters.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to
4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces
contain the same designated router priority value, the interface with the largest interface IP address becomes the
designated router.
PIM-Sparse Mode (PIM-SM) 961