Service Manual

ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the PIM-SM router from creating
state based on multicast source and/or group.
Syntax
ipv6 pim join-filter access-list
Parameters
access-list Enter the name of an extended access list.
in Enter the keyword in to apply the access list to inbound traffic.
out Enter the keyword out to apply the access list to outbound traffic.
Defaults none
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf)#ipv6 access-list JOIN-FIL_ACL
Dell(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
Dell(conf-ipv6-acl)#exit
Dell(conf)#interface tengigabitethernet 0/84
Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in
Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The range is
from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
962 PIM-Sparse Mode (PIM-SM)