Service Manual

Command Modes EXEC
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Messages can contain an unlimited number of lines; however, each line is limited to 255 characters. To move to
the next line, use <CR>. To send the message use CTR-Z; to abort a message, use CTR-C.
service timestamps
To debug and log messages, add time stamps. This command adds either the uptime or the current time and date.
Syntax
service timestamps [debug | log] [datetime [localtime] [msec] [show-timezone] |
uptime]
Parameters
debug (OPTIONAL) Enter the keyword debug to add timestamps to debug messages.
log (OPTIONAL) Enter the keyword log to add timestamps to log messages with severity
from 0 to 6.
datetime (OPTIONAL) Enter the keyword datetime to have the current time and date added to
the message.
localtime (OPTIONAL) Enter the keyword localtime to include the localtime in the timestamp.
msec (OPTIONAL) Enter the keyword msec to include milliseconds in the timestamp.
show-timezone (OPTIONAL) Enter the keyword show-timezone to include the time zone information
in the timestamp.
uptime (OPTIONAL) Enter the keyword uptime to have the timestamp based on time elapsed
since system reboot.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you do not specify parameters and enter service timestamps, it appears as service timestamps
debug uptime in the running-configuration.
To view the current options set for the service timestamps command, use the show running-config
command.
show alarms
View alarms.
Syntax
show alarms
Control and Monitoring 97