Service Manual

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for the RPM / ERPM.
8.3.16.1 Introduced on the M I/O Aggregator.
Related Commands
monitor session — enables a monitoring session.
erpm
Configure the source and destination IP address for ERPM traffic.
Syntax
erpm source-ip ip-address dest-ip ip-address [gre-protocol value]
To remove the configuration, use the no erpm source-ip IP-address dest-ip IP-address [gre-
protocol value] command.
Parameters
source–ip ip-
address
Enter the keywords source-ip then the source IP address in dotted decimal format.
destination–ip ip-
address
Enter the keywords dest-ip then the destination IP address in dotted decimal format.
gre–protocol value (OPTIONAL) Enter the keywords gre-protocol then the protocol type value for
ERPM type monitor session. The range is from 1 to 65535.
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Example
Dell(conf-mon-sess-10)#erpm source-ip 10.10.10.1 dest-ip 5.1.1.2 gre-protocol
1111
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced GRE protocol support.
Related Commands
• monitor session — creates a session for monitoring traffic with port monitoring.
• show monitor session — displays information about monitor configurations.
flow-based enable
Enable flow-based monitoring.
Syntax
flow-based enable
Port Monitoring 971