Service Manual

To disable flow-based monitoring, use the no flow-based enable command.
Defaults Disabled, that is flow-based monitoring is not applied.
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for the RPM/ERPM.
9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module platform.
8.1.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced on the E-Series.
Usage Information To monitor traffic with particular flows the interface, appropriate ACLs has be applied in ingress direction. Flow-
based is not supported in the tx direction. Even though we can configure it in both the direction, only rx will work.
The flow- based enable command has to be applied as a monitor session with some configuration which is already
present in it, other wise flow- based will not take effect.
Related Commands
monitor session – enables a monitoring session.
monitor session
Create a session for monitoring traffic with port monitoring.
Syntax
monitor session session-ID (type { rpm | erpm }) [drop]
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID Enter a session identification number. The range is from 0 to 65535.
type rpm | erpm Specifies one of the following type:
• rpm: to create remote port monitoring session.
• erpm: to create encapsulated remote port monitoring session.
• If no option is specified, by default SPAN will be created.
drop Monitors only the dropped packets in the Ingress.
Defaults none
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Added the drop parameter.
9.4(0.0) Added support for rpm / erpm.
972 Port Monitoring