Service Manual

Version Description
8.3.16.1 Introduced on the M I/O Aggregator.
Usage Information The monitor command is saved in the running configuration at Monitor Session mode level and can be restored
after a chassis reload.
Example
Dell(conf)# monitor session 60
Dell(conf-mon-sess-60)
Related Command
show monitor session — displays the monitor session.
show running-config monitor session — displays the running configuration of a monitor session.
rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000 Megabits per second.
Defaults 60
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
monitor session — enables a monitoring session.
show monitor session — displays the monitor session.
show config
Display the current monitor session configuration.
Syntax
show config
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Port Monitoring 973