Service Manual

Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the M I/O Aggregator.
Usage Information The monitoring command is saved in the running configuration at the Monitor Session mode level and can be
restored after a chassis reload.
Example
Dell# show running-config monitor session
!
monitor session 1
source TenGigabitEthernet 0/1 destination TenGigabitEthernet 0/2 direction rx
Related Commands
monitor session — creates a session for monitoring.
show monitor session — displays a monitor session.
source (port monitoring)
Configure a port monitor source.
Syntax
source {interface | range | any} destination interface direction {rx | tx |
both}
To disable a monitor source, use the no source interface destination interface direction
{rx | tx | both} command.
Parameters
source interface Enter the one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a VLAN interface enter the keyword VLAN then by a number range from 1 to
4094.
• For a port channel interface, enter the keyword LAG then port channel and the port-
channel id .
range Enter the keyword range to specify a list of interfaces.
any Enter the keyword any to specify all interfaces.
NOTE: This option is applicable only with drop monitor session.
destination Enter the keyword destination to specify the destination interface.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
Port Monitoring 975