Service Manual

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port channel interface, enter the keyword LAG then port channel and the port-
channel id .
interface Enter the one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a VLAN interface enter the keyword VLAN followed by a number from 1 to 4094.
• For a port channel interface, enter the keyword LAG then port channel and the port-
channel id .
direction {rx | tx |
both}
Enter the keyword direction then one of the packet directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Added the any parameter.
9.4(0.0) Added support for Source and destination.
8.3.16.1 Introduced on the M I/O Aggregator.
Example
Dell# monitor session 0
source Port-channel 10 destination TenGigabitEthernet 0/8 direction tx
976 Port Monitoring