Service Manual

ManualsBrandsDell ManualsserversDell Force10 MXL Blade

100

[4/20 10:27:56]: CMD-(CLI):[show interfaces tengigabitethernet 0/3]by default

from

console

[4/20 10:55:8]: CMD-(CLI):[show lldp neighbors]by default from console

[4/20 15:17:6]: CMD-(CLI):[show cam-acl]by default from console

[4/20 16:34:59]: CMD-(CLI):[show running-config interface tengigabitethernet

0/1

55]by default from console

[4/20 16:38:14]: CMD-(CLI):[show vlan]by default from console

[5/4 9:11:52]: CMD-(TEL0):[show version]by admin from vty0 (10.11.68.14)

[5/4 9:12:9]: CMD-(TEL0):[show hosts]by admin from vty0 (10.11.68.14)

[5/4 9:14:38]: CMD-(TEL0):[show arp]by admin from vty0 (10.11.68.14)

[5/4 9:19:29]: CMD-(TEL0):[enable]by admin from vty0 (10.11.68.14)

[5/4 9:19:35]: CMD-(TEL0):[configure]by admin from vty0 (10.11.68.14)

- Repeated 1 time.

[5/4 9:19:50]: CMD-(TEL0):[interface tengigabitethernet 0/9]by admin from vty0

(10.11.68.14)

[5/4 9:20:11]: CMD-(TEL0):[exit]by admin from vty0 (10.11.68.14)

Dell#

Related Commands clear command history — clears the command history log.

show cpu-traffic-stats

View the CPU traffic statistics.

Syntax

show cpu-traffic-stats [port number | all]

Parameters

port number (OPTIONAL) Enter the port number to display traffic statistics on that port only. The

range is from 1 to 1568.

all (OPTIONAL) Enter the keyword all to display traffic statistics on all the interfaces

receiving traffic, sorted based on the traffic.

Defaults all

Command Modes EXEC

Command History

Version Description

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed first. All

CPU and port information is displayed unless a specific port or CPU is specified. Traffic information is displayed for

router ports only; not for management interfaces. The traffic statistics are collected only after the debug cpu-

traffic-stats command is executed; not from the system bootup.

NOTE: After debugging is complete, use the no debug cpu-traffic-stats command to shut off

traffic statistics collection.

Example

Dell#show cpu-traffic-stats

Processor : CP

--------------

Received 100% traffic on TenGigabitEthernet 1/4 Total packets:100

LLC:0, SNAP:0, IP:100, ARP:0, other:0

Unicast:100, Multicast:0, Broadcast:0

Dell#

Related Commands debug cpu-traffic-stats — enables CPU traffic statistics for debugging.

Control and Monitoring 99