Administrator Guide
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
Capabilities advertised to neighbor for IPv4 Unicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
For address family: IPv4 Unicast
BGP table version 1395, neighbor version 1394
Prefixes accepted 1 (consume 4 bytes), 0 withdrawn by peer
Prefixes advertised 0, rejected 0, 0 withdrawn from peer
Connections established 3; dropped 2
Last reset 00:00:12, due to Missing well known attribute
Notification History
'UPDATE error/Missing well-known attr' Sent : 1 Recv: 0
'Connection Reset' Sent : 1 Recv: 0
PDU Counters
The Dell Networking OS version 7.5.1.0 introduces additional counters for various types of PDUs sent and received from neighbors.
These are seen in the output of the show ip bgp neighbor command.
Sample Congurations
The following example congurations show how to enable BGP and set up some peer groups. These examples are not
comprehensive directions. They are intended to give you some guidance with typical congurations.
To support your own IP addresses, interfaces, names, and so on, you can copy and paste from these examples to your CLI. Be sure
that you make the necessary changes.
The following illustration shows the congurations described on the following examples. These congurations show how to create
BGP areas using physical and virtual links. They include setting up the interfaces and peers groups with each other.
196
Border Gateway Protocol IPv4 (BGPv4)