Administrator Guide

Dell(conf)# interface vlan 10
Dell(conf-if-vl-10)# fip-snooping enable
Dell(conf-if-vl-10)# fip-snooping fc-map 0xOEFC01
NOTE: Conguring an FC-MAP value is only required if you do not use the default FC-MAP value (0x0EFC00).
Dell(conf)# interface tengigabitethernet 0/1
Dell(conf-if-te-0/1)# portmode hybrid
Dell(conf-if-te-0/1)# switchport
NOTE: A port is enabled by default for bridge-ENode links.
Dell(conf)# interface tengigabitethernet 0/50
Dell(conf-if-te-0/50)# portmode hybrid
Dell(conf-if-te-0/50)# switchport
Dell(conf-if-te-0/50)# fip-snooping port-mode fcf
Dell(conf)# interface vlan 10
Dell(conf-if-vl-10)# tagged tengigabitethernet 0/1
Dell(conf-if-vl-10)# tagged tengigabitethernet 0/50
Dell(conf-if-te-0/1)# no shut
Dell(conf-if-te-0/50)# no shut
Dell(conf-if-vl-10)# no shut
After FIP packets are exchanged between the ENode and the switch, a FIP snooping session is established. ACLs are dynamically
generated for FIP snooping on the FIP snooping bridge/switch.
FCoE Transit
315