Administrator Guide

Example of the show interfaces port-channel brief Command
Example of the show interface port-channel Command
Example of Error Due to an Attempt to Congure an Interface that is Part of a Port Channel
To view the port channel’s status and channel members in a tabular format, use the show interfaces port-channel
brief
command in EXEC Privilege mode, as shown in the following example.
Dell#show int port brief
Codes: L - LACP Port-channel
LAG Mode Status Uptime Ports
1 L3 down 00:00:00 Te 0/16 (Down)
Dell#
The following example shows the port channel’s mode (L2 for Layer 2 and L3 for Layer 3 and L2L3 for a Layer 2-port channel
assigned to a routed VLAN), the status, and the number of interfaces belonging to the port channel.
Dell#show int port-channel
Port-channel 1 is down, line protocol is down
Hardware address is 00:1e:c9:f1:00:05, Current address is 00:1e:c9:f1:00:05
Interface index is 1107755009
Minimum number of links to bring Port-channel up is 1
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :lag1001ec9f10005
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Members in this channel: Te 0/16(D)
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:05:44
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:05:44
When more than one interface is added to a Layer 2-port channel, the system selects one of the active interfaces in the port channel
to be the primary port. The primary port replies to ooding and sends protocol data units (PDUs). An asterisk in the show
interfaces port-channel brief command indicates the primary port.
As soon as a physical interface is added to a port channel, the properties of the port channel determine the properties of the physical
interface. The conguration and status of the port channel are also applied to the physical interfaces within the port channel. For
example, if the port channel is in Layer 2 mode, you cannot add an IP address or a static MAC address to an interface that is part of
that port channel.
In the following example, interface GigabitEthernet 1/6 is part of port channel 1, which is in Layer 2 mode, and an error message
appeared when an IP address was congured.
Dell(conf-if-po-1)#show config
!
Interfaces
355