Administrator Guide

NOTE: When creating an interface range, interfaces appear in the order they were entered and are not sorted.
To display all interfaces that have been validated under the interface range context, use the show range command in Interface
Range mode.
To display the running conguration only for interfaces that are part of interface range, use the show configuration command
in Interface Range mode.
Bulk Conguration Examples
Use the interface range command for bulk conguration.
• Create a Single-Range
• Create a Multiple-Range
• Exclude Duplicate Entries
• Exclude a Smaller Port Range
• Overlap Port Ranges
• Commas
• Add Ranges
Create a Single-Range
The following is an example of a single range.
Example of the interface range Command (Single Range)
Dell(conf)# interface range tengigabitethernet 5/1 - 23
Dell(conf-if-range-te-5/1-23)# no shutdown
Dell(conf-if-range-te-5/1-23)#
Create a Multiple-Range
The following is an example of multiple range.
Example of the interface range Command (Multiple Ranges)
Dell(conf)#interface range tengigabitethernet 3/0 , tengigabitethernet 2/1 - 47 , vlan 1000
Dell(conf-if-range-te-2/1-47)#
Exclude Duplicate Entries
The following is an example showing how duplicate entries are omitted from the interface-range prompt.
Example of the Interface-Range Prompt for Duplicate Interfaces
Dell(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
Dell(conf-if-range-vl-1,vl-3)#
Dell(conf)#interface range tengigabitethernet 2/0 - 23 , tengigabitethernet 2/0 - 23 ,
tengigab 2/0 - 23
Dell(conf-if-range-te-2/0-23)#
Exclude a Smaller Port Range
The following is an example show how the smaller of two port ranges is omitted in the interface-range prompt.
Example of the Interface-Range Prompt for Multiple Port Ranges
Dell(conf)#interface range tengigabitethernet 2/0 - 23 , tengigab 2/1 - 10
Dell(conf-if-range-te-2/0-23)#
Interfaces
359