Administrator Guide

– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For a Port Channel interface, enter the keywords port-channel then a number from 1 to 128.
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a VLAN, enter the keyword vlan then a number from 1 to 4094.
– (OPTIONAL) To clear statistics for all VRRP groups congured, enter the keyword vrrp. Enter a number from 1 to 255 as
the vrid.
– (OPTIONAL) To clear unknown source address (SA) drop counters when you congure the MAC learning limit on the
interface, enter the keywords learning-limit.
Example of the clear counters Command
When you enter this command, conrm that you want the Dell Networking OS to clear the interface counters for that interface.
Dell#clear counters tengig 0/0
Clear counters on TenGigabitEthernet 0/0 [confirm]
Dell#
Enhanced Validation of Interface Ranges
You can avoid specifying spaces between the range of interfaces, separated by commas, that you congure by using the
interface range command. For example, if you enter a list of interface ranges, such as interface range fo 2/0-1,te
10/0,gi 3/0,fa 0/0, this conguration is considered valid. The comma-separated list is not required to be separated by spaces
in between the ranges. You can associate multicast MAC or hardware addresses to an interface range and VLANs by using the
mac-
address-table static multicast-mac-address vlan vlan-id output-range interface command.
Enhanced Control of Remote Fault Indication Processing
By default, MXL module processes RFI errors transmitted by remote peers and brings down the interface when an RFI error is
detected.
You must enter the interface conguration mode before conguring Remote Fault Indication (RFI).
You can use the following CLI commands to enable or disable processing of received RFI events:
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
The default is "remote-fault-signaling rx on".
Interfaces
377