Administrator Guide

Location Description
no shutdown
2/11
Interface GigabitEthernet 2/11
ip pim sparse-mode
ip address 10.11.12.2/24
no shutdown
2/31
Interface GigabitEthernet 2/31
ip pim sparse-mode
ip address 10.11.23.1/24
no shutdown
3/1
Interface GigabitEthernet 3/1
ip pim sparse-mode
ip address 10.11.5.1/24
no shutdown
3/11
Interface GigabitEthernet 3/11
ip pim sparse-mode
ip address 10.11.13.2/24
no shutdown
3/21
Interface GigabitEthernet 3/21
ip pim sparse-mode
ip address 10.11.23.2/24
no shutdown
Receiver 1
Interface VLAN 300
ip pim sparse-mode
ip address 10.11.3.1/24
untagged GigabitEthernet 1/1
no shutdown
Receiver 2
Interface VLAN 400
ip pim sparse-mode
ip address 10.11.4.1/24
untagged GigabitEthernet 1/2
no shutdown
Preventing a PIM Router from Processing a Join
To permit or deny PIM Join/Prune messages on an interface using an extended IP access list, use the following command.
NOTE: Dell Networking recommends not using the ip pim join-filter command on an interface between a source
and the RP router. Using this command in this scenario could cause problems with the PIM-SM source registration
process resulting in excessive trac being sent to the CPU of both the RP and PIM DR of the source.
Excessive trac is generated when the join process from the RP back to the source is blocked due to a new source group
being permitted in the join-lter. This results in the new source becoming stuck in registering on the DR and the continuous
generation of UDP-encapsulated registration messages between the DR and RP routers which are being sent to the CPU.
Prevent the PIM SM router from creating state based on multicast source and/ or group.
INTERFACE
Multicast Features
533