Administrator Guide

– username: enter a text string.

– encryption-type: enter 0 for plain text or 7 for encrypted text.

– password: enter a text string.

NOTE: You cannot use the change directory (cd) command until you have congured ftp-server topdir.

To view the FTP conguration, use the show running-config ftp command in EXEC privilege mode.

Conguring FTP Client Parameters

To congure FTP client parameters, use the following commands.

• Enter the following keywords and slot/port or number information:

– For a Loopback interface, enter the keyword loopback then a number between 0 and 16383.

– For a port channel interface, enter the keywords port-channel then a number from 1 to 128.

– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

CONFIGURATION mode

ip ftp source-interface interface

• Congure a password.

CONFIGURATION mode

ip ftp password password

• Enter a username to use on the FTP client.

CONFIGURATION mode

ip ftp username name

To view the FTP conguration, use the show running-config ftp command in EXEC privilege mode, as shown in the example

for Enabling the FTP Server.

Terminal Lines

You can access the system remotely and restrict access to the system by creating user proles.

Terminal lines on the system provide dierent means of accessing the system. The virtual terminal lines (VTYs) connect you through

Telnet to the system.

Denying and Permitting Access to a Terminal Line

Dell Networking recommends applying only standard access control lists (ACLs) to deny and permit access to VTY lines.

• Layer 3 ACLs deny all trac that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny

trac.

• You cannot use the show ip accounting access-list command to display the contents of an ACL that is applied only

to a VTY line.

To apply an IP ACL to a line, Use the following command.

• Apply an ACL to a VTY line.

LINE mode

ip access-class access-list

Management