Administrator Guide

Step Task Command Command Mode
Dell# interface tengigabitEthernet
0/0Dell(config-if-te-0/0)# fcoe-map
SAN_FABRIC_ADell# interface port-channel
3Dell(config-if-po-3)# fcoe-map
SAN_FABRIC_ADell# interface
fortygigabitEthernet 0/48
Dell(config-if-
fo-0/0)# fcoe-map SAN_FABRIC_A
3
Enable the port for FCoE transmission using the map
settings.
no shutdown
INTERFACE
Applying an FCoE Map on Fabric-facing FC Ports
The MXL 10/40GbE Switch and M I/O Aggregator, with the FC Flex IO module FC ports, are congured by default to operate in N
port mode to connect to an F port on an FC switch in a fabric. You can apply only one FCoE map on an FC port.
When you apply an FCoE map on a fabric-facing FC port, the FC port becomes part of the FCoE fabric, whose settings in the FCoE
map are congured on the port and exported to downstream server CNA ports.
Each MXL 10/40GbE Switch and M I/O Aggregator, with the FC Flex IO module FC port, is associated with an Ethernet MAC
address (FCF MAC address). When you enable a fabric-facing FC port, the FCoE map applied to the port starts sending FIP
multicast advertisements using the parameters in the FCoE map over server-facing Ethernet ports. A server sees the FC port, with
its applied FCoE map, as an FCF port.
Step
Task Command Command Mode
1
Congure a fabric-facing FC port.
interface fibrechannel
slot/port
CONFIGURATION
2
Apply the FCoE and FC fabric congurations in an FCoE
map to the port. Repeat this step to apply an FCoE map to
more than one FC port, for example:
Dell# interface fi 0/0Dell(config-if-
fc-0/0)# fabric SAN_FABRIC_A
fabric
map-name
INTERFACE
FIBRE_CHANNEL
3
Enable the port for FC transmission.
no shutdown
INTERFACE
FIBRE_CHANNEL
Tip: You can apply a DCB or FCoE map to a range of Ethernet or Fibre Channel interfaces by using theinterface range
command; for example:
Dell(config)# interface range tengigabitEthernet 1/12 - 23 , tengigabitEthernet 2/24 - 35
Dell(config)# interface range fibrechannel 0/0 - 3 , fibrechannel 0/8 - 11
Enter the keywords interface range followed by an interface type and port range. A port range must contain spaces before
and after the dash. Separate each interface type and port range with a space, comma, and space as shown in the preceding
examples.
Sample Conguration
1. Congure a DCB map with PFC and ETS settings:
Dell(config)# dcb-map SAN_DCB_MAP
Dell(config-dcbx-name)# priority-group 0 bandwidth 60 pfc off
Dell(config-dcbx-name)# priority-group 1 bandwidth 20 pfc on
FC Flex IO Modules
935