Reference Guide

244 | Interfaces
www.dell.com | support.dell.com
interface loopback
Configure a Loopback interface.
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
Figure 14-8. interface loopback Command Example
Related
Commands
interface ManagementEthernet
Configure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
Figure 14-9. interface ManagementEthernet Command Example
Usage
Information
You cannot delete a Management port.
number
Enter a number as the interface number.
Range: 0 to 16383.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)#interface loopback 1655
FTOS(conf-if-lo-1655)#
interface Configures a physical interface.
interface null Configures a Null interface.
interface port-channel Configures a port channel.
interface vlan Configures a VLAN.
slot/port
Enter the keyword ManagementEthernet followed by slot number (0-1) and port
number zero (0).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#