Reference Guide

302 | IPv4 Routing
www.dell.com | support.dell.com
Related
Commands
ip host
Assign a name and IP address to be used by the host-to-IP address mapping table.
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
ip max-frag-count
Set the maximum number of fragments allowed in one packet for packet re-assembly.
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-count command.
Parameters
Defaults
No limit is set on number of fragments allowed.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-assembly low.
ip name-server
Enter up to 6 IPv4 addresses of name servers. The order you enter the addresses determines the order
of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
ip helper-address Specifies the destination broadcast or host address for DHCP server requests.
show running-config Displays the current configuration and changes from the default values.
name
Enter a text string to associate with one IP address.
ip-address
Enter an IP address, in dotted decimal format, to be mapped to the name.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
count
Enter a number for the number of fragments allowed for re-assembly.
Range: 2 to 256
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module