Reference Guide

IPv4 Routing | 305
Defaults
Enabled.
Command Modes
CONFIGURATION
Command
History
ip unreachables
Enable the generation of Internet Control Message Protocol (ICMP) unreachable messages.
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables command.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address}/mask {forwarding-router-address | managementethernet}
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 management routes. This command manages both tables.
Related
Commands
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
{ipv4-address}/mask
Enter an IPv4 address (A.B.C.D) followed by the prefix-length for
the IP address of the management interface.
forwarding-router-address
Enter an IPv4 address of a forwarding router.
managementethernet Enter the keyword managementethernet for the Management
interface.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface ManagementEthernet Configures the Management port on the system.