Command Line Reference Guide

Quality of Service (QoS) | 1213
Example
Figure 48-9. show qos class-map Command Output
Related
Commands
show qos policy-map
c e s
View the QoS policy map information.
Syntax
show qos policy-map {summary [interface] | detail [interface]}
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Force10#show qos class-map
Class-map match-any CM
Match ip access-group ACL
class-map Identify the class map
summary interface To view a policy map interface summary, enter the keyword summary and
optionally one of the following keywords and slot/port or number information:
For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
detail interface
To view a policy map interface in detail, enter the keyword detail and optionally
one of the following keywords and slot/port or number information:
For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series only: Added Trust IPv6 diffserv
Version 6.2.1.1 Introduced on E-Series