Command Line Reference Guide

138 | Control and Monitoring
www.dell.com | support.dell.com
E-Series Example
Figure 5-52. Command Example: show rpm on E-Series
Table 5-7 defines the fields displayed in Figure 5-52.
Table 5-7. Descriptions of show rpm output
Field Description
Status Displays the RPM’s status.
Next Boot Displays whether the RPM is to be brought online at the next system reload.
Card Type Displays the RPM catalog number.
Hardware Rev Displays theE-Series chipset hardware revision level: 1.0 (non-Jumbo); 1.5
(Jumbo-enabled); 2.0 (or above is TeraScale).
Num Ports Displays the number of active ports.
Up Time Displays the number of hours and minutes since the RPM’s last reboot.
Last Restart States the reason for the last RPM reboot.
C-Series possible values:
“normal power-cycle” (
reset power-cycle command)
“reset by master” (peer RPM reset by master RPM)
“over temperature shutdown”
“power supply failed”
E-Series possible values:
“normal power-cycle” (insufficient power, normal power cycle)
“reset by user” (automatic failover, software reload of both RPMs, or
master RPM resetting peer)
“force-failover” (
redundancy force-failover command)
FTOS Version Displays the operating software version.
Jumbo Capable Displays a Yes or No indicating if the RPM is capable of sending and receiving
Jumbo frames.
This field does not indicate if the chassis is in Jumbo mode; for that
determination, use the
show chassis brief command.
Force10#show RPM 0
-- RPM card 0 --
Status : active
Next Boot : online
Card Type : RPM - Route Processor Module (LC-EF-RPM)
Hardware Rev : 2.0
Num Ports : 1
Up Time : 36 min, 51 sec
Last Restart : reset
FTOS Version : 6.2.1.0
Jumbo Capable : yes
CP Boot Flash : A: 2.4.0.6 B: 2.4.0.7 [booted]
RP1 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5
RP2 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5
CP Mem Size : 536870912 bytes
RP1 Mem Size : 0 bytes
RP2 Mem Size : 0 bytes
Temperature : 49C
Power Status : PEM0: absent or down PEM1: up
Voltage : ok
Serial Number : 0016788
Part Number : 7520013800 Rev 01
Vendor Id : 01
Date Code : 06182004
Country Code : 01
Force10#