Command Line Reference Guide

ManualsBrandsDell ManualsNetworkingForce10 S25-01-GE-24P

1541

1546 | E-Series ExaScale Debugging and Diagnostics

www.dell.com | support.dell.com

Command

History

Example

Figure 66-6. show console lp 0 command Example

reset sfm

Reset a specific SFM module (power-off and then power-on).

Syntax

reset sfm slot-number

Parameters

Defaults

No default values or behavior

Command Modes

EXEC

Command

History

Usage

Information

When an error is detected on an SFM module, this command is a manual recovery mechanism. Since

this command can be used with live traffic running, the switch fabric will not go down if the switch

fabric is in an UP state. When there is a full set of SFMs online in the chassis, resetting one SFM will

reduce the total bandwidth supported by the chassis and may affect data flow. A warning message is

issued at the command line and requires user confirmation to proceed.

Example

Figure 66-7. reset sfm error message

This command does not permit resetting any SFM when the system has (max-1) SFM and switch fabric

is up).

Version 8.1.1.2 Introduced on E-Series ExaScale E600i

Version 8.1.1.0 Introduced on E-Series ExaScale E1200i

Force10#show console lp 0

MINI FIFO CONTROL = 0x0a

MINI FIFO RPM POINTER = 0x000

MINI FIFO CPU POINTER = 0xb0b

Default case. type = 5

frrpaProcessIfmNotif(): Default case. type = 69

frrpaProcessIfmNotif(): Default case. type = 70

frrpaProcessIfmNotif(): Default case. type = 5

frrpaProcessIfmNotif(): Default case. type = 11

frrpaProcessIfmNotif(): Default case. type = 5

frrpaProcessIfmNotif(): Default case. type = 11

Force10#

slot-number

Enter the slot number of the SFM to reset.

Range: 0 to 7

Version 8.1.1.0 Introduced on E-Series ExaScale

Force10#reset sfm 0

SFM0 is active. Resetting it might temporarily impact data traffic.

Proceed with reset [confirm yes/no]:yes

Feb 16 00:39:30: %RPM1-P:CP %TSM-5-SFM_DISCOVERY: Found SFM 0

Force10#