Command Line Reference Guide

Access Control Lists (ACL) | 243
Command
History
Usage
Information
The monitor option is relevant in the context of the flow-based monitoring feature only. See
Chapter 45, Port Monitoring.
When you use the log option, CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
The order option is relevant in the context of the Policy QoS feature only. The following applies:
The seq sequence-number is applicable only in an ACL group.
The order option works across ACL groups that have been applied on an interface via QoS policy
framework.
The order option takes precedence over the seq sequence-number.
If sequence-number is not configured, then rules with the same order value are ordered
according to their configuration order.
If the sequence-number is configured, then the sequence-number is used as a tie breaker for
rules with the same order.
If the sequence-number is configured, then the sequence-number is used as a tie breaker for rules
with the same order.
Related
Commands
Common MAC Access List Commands
The following commands are available within both MAC ACL modes (Standard and Extended) and do
not have mode-specific options.
c and s platforms support Ingress MAC ACLs only.
The following commands allow you to clear, display and assign MAC ACL configurations.
clear counters mac access-group
mac access-group
show mac access-lists
show mac accounting access-list
Version 8.3.1.0 Add DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 7.4.1.0
Added support for non-contiguous mask and added the
monitor option. Deprecated
established keyword
Version 6.5.10
Expanded to include the optional QoS
order priority for the ACL entry.
Note: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
deny Configure a filter to drop packets.
permit Configure a filter to forward packets.