Command Line Reference Guide

Content Addressable Memory (CAM) for ExaScale | 423
Usage
Information
CAM profile changes take effect after the next chassis reboot.
CAM-profile template region allocations are not automatically configured when you select a template.
Us e the allocations shown in the Content Addressable Memory for ExaScale chapter in the FTOS
Configuration Guide for detailed values supported in each CAM/SRAM region.
enable
e
x
Enable CAM-profile template.
Syntax
enable
Defaults
cam-profile default microcode default
Command Modes
CONFIGURATION-CAM-profile-template
Command
History
Usage
Information
You must save the running configuration using the command copy running-config startup-config
after changing the CAM-profile. CAM-profile template changes take effect after the next chassis
reboot.
flow
e
x
Configure the Flow region for a CAM-profile template
Syntax
flow [ipv4 | ipv6] multicast-fib {value} pbr {value} qos {value} system-flow {value}
Defaults
None
Command Modes
CONFIGURATION-CAM-profile-template
Command
History
Usage
Information
You do not need to enter every parameter for a region. You can enter only the ones you need.
User configured CAM-profiles are automatically validated.
Refer to Chapter 11, Content Addressable Memory for ExaScale in the FTOS Configuration Guide for
detailed values supported in each CAM/SRAM region.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 8.2.1.0 Introduced on E-Series ExaScale