Command Line Reference Guide
BOOT_USER Mode | 59
4
BOOT_USER Mode
Overview
All commands in this chapter are in the BOOT_USER mode except for format, which is in the
BOOT_ADMIN mode. Command support on Dell Force10 platforms is indicated by the characters
that appear below each command heading:
• c = C-Series
•
e = E-Series
• s = S-Series
To access this mode in the C-Series and E-Series, enter a control break sequence (Ctrl^, which is Ctrl
Shift-6) when the following line appears on the console during a system boot:
Send the Break Signal to stop Operating System auto-boot...
On the S-Series, the following is displayed twice. Press any key when the following line is displayed
the second time:
Hit any key to break into BOOT_USER mode
Commands
• boot change
• boot messages
• boot selection
• boot zero
• default-gateway
• delete
• dir
• enable
• format
• ignore enable-password
• ignore startup-config
• interface management ethernet ip address
• interface management ethernet mac-address
• interface management ethernet port
• interface management port config
• reload
• rename
• restore factory-defaults