Command Line Reference Guide

616 | Interfaces
www.dell.com | support.dell.com
Usage
Information
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command
on the interface. To use the switchport command on an interface, only the no ip address and no
shutdown statements must be listed in the show config output.
When you enter the switchport command, the interface is automatically added to the default VLAN.
To use the switchport backup interface command on a port, you must first enter the switchport
command. For details, see the Configuring Redundant Links section in the Layer 2 chapter of the
FTOS Configuration Guide.
Related
Commands
wanport
e
Enable the WAN mode on a TenGigabitEthernet interface.
Syntax
wanport
To disable the WAN Port, enter no wanport.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa as
shown in the figure below.
For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either WANPHY or
non-WANPHY. They cannot be mixed on the same port-pipe.
Example
Figure 24-42. wanport Command with shutdown Command Example
Related
Commands
interface port-channel Create a port channel interface.
show interfaces switchport Display information about switchport interfaces.
Version 8.1.1.2 Introduced on E-Series ExaScale
pre-Version 6.2.1.0 Introduced for E-Series
interface TenGigabitEthernet 13/0
no ip address
no shutdown
Force10(conf-if-te-13/0)#
Force10(conf-if-te-13/0)#wanport
% Error: Port should be in shutdown mode, config ignored Te 13/0.
Force10(conf-if-te-13/0)#
Force10(conf-if-te-13/0)#shutdown
Force10(conf-if-te-13/0)#
Force10(conf-if-te-13/0)#wanport
Force10(conf-if-te-13/0)#
ais-shut Send LAIS on shutdown
alarm-report Enable reporting of a selected alarm
clock source Configure a clock source
down-when-looped Send a message when a loopback condition is detected
flag Set flags to ensure interoperability