Command Line Reference Guide

620 | Interfaces
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
Figure 24-43. interface port-channel Command Example
Usage
Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the
switchport command) or Layer 3 mode (by configuring an IP address). You can add a Port Channel in
Layer 2 mode to a VLAN.
The shutdown, description, and name commands are the only commands that you can configure on an
interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the
interface can only have the shutdown, description, and name commands configured. The Port
Channel’s configuration is applied to the interfaces within the Port Channel.
A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on the first interface
configured in the Port Channel and enabled, FTOS determines if the Port Channel uses 100 Mb/s or
1000 Mb/s as the common speed. Refer to channel-member for more information.
If the line card is in a Jumbo mode chassis, then the mtu and ip mtu commands can also be configured.
The Link MTU and IP MTU values configured on the channel members must be greater than the Link
MTU and IP MTU values configured on the Port Channel interface.
Related
Commands
minimum-links
c e s
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for
the LAG to be also in “oper up” status.
Syntax
minimum-links number
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
Force10(conf)#int port-channel 2
Force10(conf-if-po-2)#
Note: In a Jumbo-enabled system, all members of a Port Channel must be configured with the
same link MTU values and the same IP MTU values.
channel-member Add a physical interface to the LAG.
interface Configure a physical interface.
interface loopback Configure a Loopback interface.
interface null Configure a null interface.
interface vlan Configure a VLAN.
shutdown Disable/Enable the port channel.