Command Line Reference Guide

622 | Interfaces
www.dell.com | support.dell.com
Command Modes
INTERFACE PORTCHANNEL
Example
Figure 24-44. show config Command Sample Output for a Selected LAG
Command
History
show interfaces port-channel
c e s
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Force10(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
Force10(conf-if-po-1)#
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
channel-number For a Port Channel interface, enter the keyword port-channel followed by
a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
brief (OPTIONAL) Enter the keyword brief to display only the port channel
number, the state of the port channel, and the number of interfaces in the port
channel.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced for S-Series; Modified to display LAG failover group status
Version 7.5.1.0 Introduced for C-Series
E-Series legacy command