Administrator Guide

management-interface
Enable and configure LLDP protocol parameters on the management interface.
Z9000
Syntax
management-interface
To remove LLDP configuration on a management interface, use the no
management-interface command.
Command
Modes
LLDP (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(0.2) Introduced on the Z9000 and S4810.
Usage
Information
To enable LLDP on the management interface, use the no disable command in
LLDP-MANAGEMENT-INTERFACE mode (conf-lldp-mgmtIf).
mode
To receive or transmit, set LLDP.
Z9000
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Defaults Both transmit and receive.
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1006
Link Layer Discovery Protocol (LLDP)