Administrator Guide

debug cpu-traffic-stats
Enable the collection of computer processor unit (CPU) traffic statistics.
Syntax
debug cpu-traffic-stats
To disable the debugging, use the no debug cpu-traffic-stats command.
Defaults Disabled
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
This command enables (and disables) the collection of CPU traffic statistics from
the time this command is executed (not from system boot). However, excessive
traffic a CPU receives automatically triggers (turn on) the collection of CPU traffic
statics.
The following message is an indication that collection of CPU traffic is
automatically turned on. To view the traffic statistics, use the show cpu-
traffic-stats
command.
If the CPU receives excessive traffic, traffic is rate controlled.
NOTE: This command must be enabled before the show cpu-traffic-
stats
command displays traffic statistics. Dell Networking recommends
disabling debugging (no debug cpu-traffic-stats) after troubleshooting
is complete.
Related
Commands
show cpu-traffic-stats — displays the cpu traffic statistics.
104
Control and Monitoring