Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
ipv6 nd ra-guard policy
Define the RA guard policy name and enter the RA guard policy list configuration mode.
Syntax
ipv6 nd ra-guard policy policy-name
Parameters
policy policy-
name
Enter the keyword policy then the policy-name. The policy
name allows a maximum of 140 characters.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
Syntax
ipv6 neighbor {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor {
ipv6-address} {interface interface} command.
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
Neighbor Discovery Protocol (NDP)
1077