Administrator Guide

vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TELNET server.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage
Information
You can enable the TELNET server on either a management VRF or a user-defined
VRF but not both. If you do not specify a VRF name, then the TELNET server is
enabled on the default VRF.
Example
Dell(conf)#ip telnet server vrf vrf1
Dell(conf)#no ip telnet server vrf
Dell(conf)#ip telnet server vrf management
Dell(conf)#no ip telnet server vrf
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
To return to the default setting, use the no ip telnet source-interface
[
interface] command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
122
Control and Monitoring