Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip pim neighbor command shown in the
following example.
Field Description
Neighbor address Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID
(VLAN or Port Channel), on which the PIM neighbor was
found.
Uptime/expires Displays the amount of time the neighbor has been up then
the amount of time until the neighbor is removed from the
multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number.
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode.
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
127.87.3.4 Te 1/16 09:44:58/00:01:24 v2 1 / S
Dell#
1252
PIM-Sparse Mode (PIM-SM)