Administrator Guide

show monitor session
Display information about monitoring sessions.
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor
session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range
is from 0 to 65535.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4.0.0 Added support for the RPM / ERPM.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell#show monitor session 1
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL
------ ------ ----------- --- ---- --------- -------- ------
-----
1 Te 1/2 remote-ip rx Port 0.0.0.0 0.0.0.0 0 0
Dell#show monitor session
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL
------ ------ ----------- --- ---- --------- -------- ------
----
1 Te 1/2 remote-ip rx Port 0.0.0.0 0.0.0.0 0 255
99 NONE NONE N/A N/A N/A N/A N/A N/A
Port Monitoring
1281