Administrator Guide

Defaults none
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Information
The list of secondary VLANs can be:
• Specified in comma-delimited or hyphenated-range format.
• Specified with this command even before they have been created.
• Amended by specifying the new secondary VLAN to be added to the list.
Related
Commands
private-vlan mode — sets the mode of the selected VLAN to community, isolated,
or primary.
switchport mode private-vlan — sets PVLAN mode of the selected port.
switchport mode private-vlan
Set PVLAN mode of the selected port.
Z9000
Syntax
[no] switchport mode private-vlan {host | promiscuous | trunk}
To remove PVLAN mode from the selected port, use the no switchport mode
private-vlan command.
Parameters
host Enter the keyword host to configure the selected port or
port channel as an isolated interface in a PVLAN.
promiscuous Enter the keyword promiscuous to configure the selected
port or port channel as an promiscuous interface.
Private VLAN (PVLAN)
1289