Administrator Guide

Version Description
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple
neighbor routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface command with the neighbor command.
Related
Commands
passive-interface — sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
Z9000
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Defaults No RIP network is configured.
Command
Modes
ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Routing Information Protocol (RIP)
1379