Administrator Guide

• line for LINE mode
• route-map for ROUTE-MAP mode
• router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS
and ROUTER BGP modes
level level Enter the keyword level then a number for the access level.
The range is from 0 to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI
modes and commands.
reset Enter the keyword reset to return the security level to the
default setting.
command Enter the command’s keywords to assign the command to a
certain access level. You can enter one or all of the
keywords.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
To define a password for the level to which you are assigning privilege or access,
use the enable password command.
privilege level (LINE mode)
Change the access level for users on the terminal lines.
Syntax
privilege level level
To delete access to a terminal line, use the no privilege level level
command.
1436
Security