Administrator Guide

Usage
Information
This command displays the contents of the flash:/ADMIN_DIR/ssh/
authorized-keys.username file.
Example
Dell#show ip ssh rsa-authentication my-authorized-keys
ssh-rsa
AAAAB3NzaC1yc2EAAAABIwAAAIEAyB17l4gFp4r2DRHIvMc1VZd0Sg5GQxRV1y1
X1JOMeO6Nd0WuYyzrQMM
4qJAoBwtneOXfLBcHF3V2hcMIqaZN+CRCnw/
zCMlnCf0+qVTd1oofsea5r09kS0xTp0CNfHXZ3NuGCq9Ov33m9+U9tMwhS8vy8A
VxdH4x4km3c3t5Jvc=
freedom@poclab4
Dell#
Related
Commands
ip ssh rsa-authentication (Config) — configures the RSA authorized keys.
ssh
Open an SSH connection specifying the hostname, username, encryption cipher, HMAC algorithm, port
number, and version of the SSH client.
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
ssh {hostname | ipv4 address | ipv6 address} [-c encryption
cipher | -l username | -m HMAC algorithm | -p port-number | -v
{1 | 2}]
Parameters
hostname (OPTIONAL) Enter the IP address or the host name of the
remote device.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf then the
VRF Instance name to open an SSH connection to that
instance.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format
A.B.C.D.
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
-c encryption
cipher
Enable the “FIPS mode enable", this mode will support only
v2 client.
"no fips mode enable"(disable) will support v1 & v2 client.
This comment is applicable for both ciphers & HMAC
algorithms:
• 3des-cbc: Force ssh to use 3des-cbc encryption cipher.
1508
Security