Administrator Guide

hostname Enter the name of a host already configured and recognized
by the switch.
udp Enter the keyword udp to enable transmission of log
message over UDP followed by port number. The default
port is 514
tcp Enter the keyword tcp to enable transmission of log
message over TCP followed by port number.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added udp and tcp keywords for the S4810, S4820T,
S6000, Z9000, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for IPv6.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Multiple logging servers of both IPv4 and/or IPv6 can be configured.
Related
Commands
logging on — enables the logging asynchronously to logging buffer, console,
Syslog server, and terminal lines.
logging trap — enables logging to the Syslog server based on severity.
Simple Network Management Protocol (SNMP) and Syslog
1573