Administrator Guide

Example
Dell(conf)#protocol spanning-tree 0
Dell(config-stp)#
Related
Commands
disable — disables spanning tree group 0. To enable spanning tree group 0, use the
no disable command.
show config
Display the current configuration for the mode. Only non-default values display.
Syntax
show config
Command
Modes
SPANNING TREE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-stp)#show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
show spanning-tree 0
Display the spanning tree group configuration and status of interfaces in the spanning tree group.
Syntax
show spanning-tree 0 [active | brief | guard | interface
interface | root | summary]
1624
Spanning Tree Protocol (STP)