Administrator Guide

configure any tunnel allow-remote entries, the tunnel—mode command fails
unless the decapsulate-any option is included.
Configuration of IPv6 commands over decapsulate-any tunnel causes an error.
tunnel source
Set a source address for the tunnel.
Syntax
tunnel source {ip-address | ipv6–address | interface-type-
number | anylocal}
To delete the current tunnel source address, use the no tunnel source
command.
Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
interface-type-
number
• For a port channel interface, enter the keywords port-
channel then a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
anylocal
Enter the anylocal command to allow the multipoint
receive-only tunnel to decapsulate tunnel packets destined
to any local ip address.
Defaults none
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the tunnel source anylocal command.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Added an optional keyword “anylocal” to the tunnel source command. The
anylocal argument can be used in place of the ip address or interface, but only with
the multipoint receive-only mode tunnels. The tunnel source anylocal command
1650
Tunneling