Administrator Guide

Parameters
value Enter the timeout value in seconds. The range is from 1 to
1200. The default is 150.
Command
Modes
VLT DOMAIN (conf-vlt-domain)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
peer-link port-channel
Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.
Syntax
peer-link port-channel port-channel-number {peer-down-vlan vlan
id}
Parameters
port-channel-
number
Enter the port-channel number that acts as the interconnect
trunk. The range is from 1 to 128.
peer-down-
vlan vlan id
Enter the keyword peer-down-vlan then a VLAN ID to
configure the VLAN that the VLT peer link uses when the VLT
peer is down.
Defaults Not configured.
Command
Modes
VLT DOMAIN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1676
Virtual Link Trunking (VLT)