Administrator Guide

Common IP ACL Commands
The following commands are available within both Ingress and Egress IP ACL modes (Standard and
Extended) and do not have mode-specific options. When an ACL is created without a rule and then is
applied to an interface, ACL behavior reflects an implicit permit.
The Z9000 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
access-class
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name
To remove an ACL, use the no access-class access-list-name command.
Parameters
access-list-
name
Enter the name of a configured Standard ACL, up to 140
characters.
Defaults Not configured.
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increase the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
188
Access Control Lists (ACL)