Administrator Guide

out Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to
change the default action of the ACL from implicit-deny to
implicit-permit (that is, if the traffic does not match the filters
in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of
the VLANs. The range is from 1 to 4094 (you can use IDs
from 1 to 4094).
Defaults Not enabled.
Command
Modes
INTERFACE/VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
You can assign one ACL (standard or extended ACL) to an interface.
NOTE: This command supports Loopback interfaces EE3 and EF series route
processor modules (RPMs). This command does not support Loopback
interfaces ED series RPMs and S-Series Loopback interfaces.
NOTE: If you apply outbound(egress) IP acl on a switch port, the filter applies
only for routed traffic egressing out of that port.
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — configures an extended ACL.
190
Access Control Lists (ACL)