Administrator Guide

deny bandwidth
Enables you to specify link band width extended-community attribute as the matching criteria to deny
incoming or outgoing traffic.
Syntax
deny bandwidth
To disable this setting, enter the no deny bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to specify extended-
community attribute as the matching criteria for denying
traffic. The range is from 0 to 102400.
Defaults N/A
Command
Modes
EXTENDED COMMUNITY LIST
Command
History
Version Description
9.7(0.0) Introduced on the S-Series.
Related
Commands
permit bandwidth – specify link band width extended-community attribute as the
matching criteria to permitting incoming or outgoing traffic..
maximum-paths
Configure the maximum number of parallel routes (multipath support) BGP supports.
Z-Series
Syntax
maximum-paths {ebgp | ibgp} number
To return to the default values, enter the no maximum-paths command.
Parameters
ebgp Enter the keyword ebgp to enable multipath support for
External BGP routes.
ibgp Enter the keyword ibgp to enable multipath support for
Internal BGP routes.
number Enter a number as the maximum number of parallel paths.
Defaults none
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol
399